Shop by ride

Return to BMW / Honda / Husqvarna / Kawasaki / Suzuki / Yamaha Exhaust Slider

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

Exhaust Slider for Eliminator August 5, 2024 Reviewer: Darren from Ohio   Fits perfectly on my Eliminator 450. Quality is great and was easy to install. I like how it adds an extra level of protection against exhaust pipe burns for my pillion, an added feature I wasn't expecting. Was this review helpful to you?

0 of 0 people found the following review helpful:

Great Exhaust Slider June 3, 2024 Reviewer: Chuck B from Texas   Installed this on my 2024 Honda Transalp 750. Good quality and easy to install, works with original bolt for the Transalp bikes. Be sure to use thread lock and check it after ~10-20 miles. I didn't use it at first and had it fairly tight but it worked itself loose after a short ride around town. After applying blue thread lock and witness mark to verify, it hasn't moved after many miles. Was this review helpful to you?

0 of 0 people found the following review helpful:

Looks great. Easy to install. August 23, 2023 Reviewer: Ron L from WV   For the Honda Rebel 1100 you will install this in place of the bolt holding the exhaust on using the included 8mm bolt.  The slider ships with a 10mm bolt pre-installed, so you will need to swap that out. I got this on in about 10 minutes, with no trouble.  My only VERY slight gripes are that there was no install instructions or videos, and the slider's plastic component has kind of a 3D printed/striated finish.  I think I would have preferred a smooth finish. Was this review helpful to you?

0 of 0 people found the following review helpful:

MT-03 stock nut won’t work July 15, 2021 Reviewer: TK from Virginia   For 2021 MT-03, you use the M8 bolt instead of the M10 bolt both of which are included in the package. Problem is that the stock nut that the instruction says you should use is a lock nut. The included M8 bolt is too long because the bolt cannot penetrate the lock nut. You instead need to find/use a regular stainless M8 nut to replace the stock nut. The build quality of this product seems excellent, though. Was this review helpful to you?

2 of 2 people found the following review helpful:

Exhaust Slider October 16, 2020 Reviewer: Larry Lulay from Oregon   I did have to use this once and you can see a photo of my bike sliding and this slider saving my exhaust.  See photo of in on my R3 at http://www.ridesdoneright.com/bikes/r3/ Was this review helpful to you?

4 of 4 people found the following review helpful:

Frame Sliders September 8, 2020 Reviewer: Eugene from Las Vegas   There’s a lot of frame/exhaust sliders out there. As with my engine guard, I did a lot of research as to which one I’d get to protect my Rebel 500. I ended up getting the T-Rex Engine Guard and their exhaust slider. Not only one but two sliders to protect both sides of the bike. Installation was simple. Also, these were the first items I ordered immediately after buying my bike. Gave me a better sense of security having them on as I would ride. Was this review helpful to you?