Shop by ride

Return to 2024 Kawasaki Eliminator 450 Windshield

Sort By:: Most Helpful Newest Rating: High to Low Rating: Low to High	Page of 1

0 of 0 people found the following review helpful:

Large Eliminator Windshield August 5, 2024 Reviewer: Darren from Ohio   Quality and fitment are second to none and I can't say enough good about that. I love the fact that it is acrylic and super thick. I have the Eliminator SE model and knew I would have to remove the headlight cowl in order for it to fit properly, would be nice if T Rex made a version that fit my SE or had headlight ring to replace the cowl, I also would have preferred something about two inches taller. Was this review helpful to you?

1 of 1 people found the following review helpful:

Eliminator Windshield May 27, 2024 Reviewer: Gary Smith from Indiana USA   A aftermarket windshield I have found over the years is a gamble as to how well is performs and the ease of installation and quality is unknow until you receive and use it. I am very satisfied with this shield on all counts.  I purchased the tall version and it performs to my expectations,  it is very sturdy and mounts solid.  The shield itself is 6mm thick and well made.   It is a  four point mount and required 4 mounting straps that no doubt was quite a challenge to design and manufacture, however everything lined up correctly making for a easy installation. For refference I am 5 ft. 6 in. Was this review helpful to you?

0 of 0 people found the following review helpful:

Well made May 21, 2024 Reviewer: Volodymyr M from Agoura Hills, CA United States   I bought a large one because I'm 6f2. It protects my chest but all air goes into my chin. That's not a problem if I close the visor and don't use my gopro. The instruction is quite basic, but it's enough if you have seen wrenches before :-) Was this review helpful to you?

0 of 0 people found the following review helpful:

High quality, well build May 2, 2024 Reviewer: Denny from Canada   Great add on. well made Was this review helpful to you?

1 of 1 people found the following review helpful:

Great addition, POOR instructions March 21, 2024 Reviewer: Neil Rhodes from Surprise, AZ United States   Great addition to the look of the bike, impact on riding yet to be determined. Instructions are terrible so just adding some context: longer (mismatched pair) of brackets fix to the odometer mounting bolts (remove OEM Allen bolts and use M6 provided with 6mm spacer under the bracket. Matched brackets bolt into the top yoke / suspension clamp with 12mm spacer and M8 bolts provided (while these brackets are the same, left and right is not obvious and I only found out when fitting the windshield, when correct, they are flush to the windshield, not even slightly “off”). Torque settings are 5 ft lb for M6 and 15 ft lb for M8. Hope this helps. Was this review helpful to you?

1 of 1 people found the following review helpful:

Well made and easy install March 19, 2024 Reviewer: Anonymous Person from Wichita, KS   The install was straightforward, just look at the photos and the shape of the brackets. Like the previous review suggested, the taller windshield seems to be much better. I am 5 foot 11 and the taller windshield cuts nearly all wind off of my body and head at 70mph+. My only complaint is that a buzzing sound resonates at certain RPMs due to my exhaust, but that's the reality of something like this. Was this review helpful to you?

1 of 2 people found the following review helpful:

Useless directions March 5, 2024 Reviewer: Rudy from Arlington, VA United States   The directions have 2 pictures, a diagram of how to put the windshield together prior to installation, that ones pretty clear and easy. Then a fuzzy black n white photo of where to install it on the bike which is absolutely useless. There's no written directions at all other than ft lbs to tighten. I think I've figured out where two of the brackets go but, f me if I can figure out two go. I've just wasted time and money... until they come up with some real directions I'd avoid this one Was this review helpful to you?

2 of 2 people found the following review helpful:

Well made but..... December 15, 2023 Reviewer: Dennis Meierer from Wilson, NY   I purchased and installed the smaller windshield on my Eliminator. The installation was straightforward and the build quality excellent. However, the windshield created substantial wind buffeting directly at my helmet. So much so that the ride soon became uncomfortable and I removed the windshield upon arriving back home. I am 6'-2" tall and perhaps someone shorter may have better results. Was this review helpful to you?