 |
- Condition: New
- Special feature: Aluminum inserts to prolong the life of the pucks
- Material: UHMW-PE (ultra high molecular weight polyethylene), High Strength Neodymium Magnets, aircraft grade aluminum
- NO CUT or plastic fairings modification required
- Fit Models: Suzuki
- 2017 - 2020 GSX-R1000 / R
- Fitting Difficulty (1-5): 3 - Average (1 - easy / 5 - Little bit of skill)
- Fitting Time: 90 - 120 minutes
- PDF Instruction: Frame Sliders
This purchase is for a set of frame sliders, front & rear axle sliders, and engine case covers for the above bike model. The sliders feature a new design of a complete solid puck with aluminum inserts to prolong the puck life. This increases the strength and contact surface to about 30%. The bracket is bolted to the engine mount and the slider puck is bolted onto it. Our axle sliders allows one to quickly remove the axle sliders without removing any bolts or screws like those in a typical slider. It facilitates quick removal of the front or rear wheel. It is an essential convenience at the track where you can promptly raise your bike as soon as you pull in a paddock. The two sides of the axle sliders are attached by high strength Neodymium magnets.The material of the pucks and covers are made of UHMW-PE (ultra high molecular weight polyethylene), a tough plastic with good strength, wear resistance and dimensional stability. It is more dimensionally stable than Nylon and used in many industrial ball bearing and friction reducing applications. Compared to Delrin, it is softer but tougher. Delrin is harder but more brittle. It is an ideal material for frame sliders since it can absorb more impact force onto itself and therefore reduce the impact on the frame and engine. The slider pucks can be inexpensively replaced in case of a low-side. We use highest grade commercially available 12.9(177,000 psi in tensile strength) wherever possible. Rest assured that you are getting the best material commercially available.
|
|
|
Rod Broke on frame slider 
