• Condition: New
• Special feature: Aircraft grade aluminum inserts to prolong puck life
• Material: UHMW-PE (ultra high molecular weight polyethylene), aircraft grade aluminum brackets with laser engravings
• NO CUT or plastic fairings modification required
• Fit Models: Honda
• 2017 - 2023 CBR1000RR ABS / Non ABS
• Fitting Difficulty (1-5): 3 - Average (1 - easy / 5 - Little bit of skill)
• Fitting Time: 90 - 120 minutes
• PDF Instruction: Frame Sliders / Case Covers

This purchase is for a set of frame sliders, engine case covers, front & rear axle sliders, and spools for the above bike model. The sliders feature a new design of a complete solid puck without a hollowed-out center. This increases the strength and contact surface to about 30%. The bracket is bolted to the engine mount and the slider puck is bolted onto it. The brackets are designed to wrap around the frame preventing them from rotating in the event of a low side. The brackets are braced together by a crossbar in order to increase its strength. The material of the pucks, spools, and case covers are made of UHMW-PE (ultra high molecular weight polyethylene), a tough plastic with good strength, wear resistance and dimensional stability. It is more dimensionally stable than Nylon and used in many industrial ball bearing and friction reducing applications. Compared to Delrin, it is softer but tougher. Delrin is harder but more brittle. It is an ideal material for frame sliders since it can absorb more impact force onto itself and therefore reduce the impact on the frame and engine. The slider pucks can be inexpensively replaced in case of a low-side. We use highest grade commercially available 12.9(177,000 psi in tensile strength) wherever possible. Rest assured that you are getting the best material commercially available.