• Condition: New
• Special feature: Brackets are designed NOT to rotate on a low side, free led kit, spool rear axle slider
• Material: UHMW-PE (ultra high molecular weight polyethylene), black anodized aircraft grade aluminum brackets
• No cut or plastic fairing modifications required
• Fit Models: Ducati
• 2017 - 2020 SuperSport S
• Fitting Difficulty (1-5): 3 - Average (1 - easy / 5 - Little bit of skill)
• Fitting Time: 90 - 120 minutes
• PDF Instruction: Frame Sliders

This purchase is for a pair of frame sliders, axle sliders, engine case covers, and fender eliminator for the above bike model. The sliders feature a new design of a complete solid puck without a hollowed-out center. This increases the strength and contact surface to about 30%. The bracket is bolted to the engine mount and the slider puck is bolted onto it. The brackets have two attachment points preventing them from rotating in the event of a low side. The fender eliminator is designed to keep out unwanted debris, dirt, mud, and etc. This kit also allows the use of the stock signal lights and comes with a free led kit for the license plate. Our rear axle slider for the Supersport also doubles as spools for the bike that allows it to be lifted by a stand.

The material of the pucks and covers are made of UHMW-PE (ultra high molecular weight polyethylene), a tough plastic with good strength, wear resistance and dimensional stability. It is more dimensionally stable than Nylon and used in many industrial ball bearing and friction reducing applications. Compared to Delrin, it is softer but tougher. Delrin is harder but more brittle. It is an ideal material for frame sliders since it can absorb more impact force onto itself and therefore reduce the impact on the frame and engine. The slider pucks can be inexpensively replaced in case of a low-side. We use highest grade commercially available 12.9(177,000 psi in tensile strength) wherever possible. Rest assured that you are getting the best material commercially available.