This purchase is for a rear axle slider that helps protect your bike in case of a low-side. It allows the fork to slide on the plastic puck instead of the fork itself. The installation is a simple bolt on with the bar going through the axle and one plastic puck on each side. The sliders are made of UHMW-PE (ultra high molecular weight polyethylene), a tough plastic with good strength, wear resistance and dimensional stability. It is more dimensionally stable than Nylon and used in many industrial ball bearing and friction reducing applications. The bolts are made of highest grade commercially available 12.9(177,000 psi in tensile strength). The long bar is made of billet aluminum. Rest assured that you are getting the best material commercially available. The frame sliders that you will receive will most likely be the ones pictured above. However, due to constant improvement, the frame sliders can sometimes vary slightly from those in the picture.
Copyright Notes: "This product is made by T-Rex Racing, Inc. All products, logos, company names displayed are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. They are used for decorative purpose only."
At T-Rex racing, Inc. we spend countless hours in developing and testing our products. We will work with our IP attorney at "The Law office of Daniel Swayze Jr." in Plano, TX to actively enforce the copyright laws for our products. Federal law also provide civil and criminal penalties and fines up to $250,000 for the unauthorized reproduction, distribution or sale of copyrighted design(Title 17, United States Code, Section 501 and 508). The FBI investigates allegations of criminal copyright infringement (Title 17, United States Code, Section 506).
Copyright © 2009 T-Rex Racing, Inc.