The stand fits Ducati 1098 S/R and 1198 S, Panigale, Streetfighter S, Diavel. The stand comes with ONE pin that will fit both sides. The pin is made of UHMW-PE polymer to prevent marring the inside of the axle and 6061-T6 aluminum for strength. It can be used to lift the bike from either side. The upright rectangular tubing provides unbeatable strength. The threaded rod is inserted through the axle hole to the other side of the wheel. The over-sized washer and the butterfly nut are attached onto the rod to prevent bike from sliding off the stand as the wheel spins. Long handle bar gives extra leverage and can be reversed to forward direction. Ball bearing pins allow the rear wheel spin easily while being lifted. The center wheel-stop rod prevents the rear wheel from spinning during removal. The stand was cleansed in chemical bath, stabilized zinc phosphate coating and finally finished with passivated zinc coating to prevent it from the elemental degradation. The stand requires a simple bolt on assembly.